My Account/Order Status
(Your shopping cart is empty)
Single Action Shooting Society (SASS)
Cowboy Mounted Shooting Association
National Rifle Association (NRA)
Join our mailing list!
LEE Factory Roll Crimp Die, Carbide for Pistol Calibers
For Handgun Ammunition That Must Work!
The Lee Factory Crimp die crimps the bullet in place more firmly than any other tool. It is impossible to buckle the case as with regular roll crimp dies. Casing trim length is not critical.
The Lee Taper Crimp Dies is a hardened steel designed to overcome crimp problems caused by poor die design. These dies offer little or no advantage when used wth 1986 or newer Lee Dies as the crimp angle is already a modified taper crimp. A carbide sizer sizes the cartridge while it is being crimped so every round will positvely chamber freely with factory-like dependability. The adjusting screw quickly and easily sets the desired amount of crimp. It is impossible to buckle the case as with a conventional bullet seating die. Trim length is not critical so this extra operation takes less time than it would if cases were trimmed and chamfered. Revolver dies roll crimp with no limit as to the amount. The crimper cannot be misadjusted to make a case mouth too small to properly head-space. A firm crimp is essential for dependable and accurate ammunition. It eliminates the problems of poor ignition of slow burning magnum powders.
Share your knowledge of this product with other customers...
Be the first to write a review
Browse for more products in the same category as this item:
Send Us Feedback
Copyright © 2007-14 Cowboy Shooting Store LLC. All Rights Reserved.